If you are installing the stereo in a location that may be exposed to water, it must be mounted within 45 degrees of the horizontal plane. The stereo must be mounted in a location that allows open airflow around the rear of the stereo for heat ventilation. What's In the Box DIN mounting plate Four 8-gauge, self-tapping screws Power and speaker wiring harness Auxiliary-in, line-out, and subwoofer-out wiring harness Tools Needed Phillips screwdriver Electric drill Drill bit (size varies based on surface material and screws used) Rotary cutting tool or jigsaw Marine sealant (optional) Mounting Considerations The stereo can be mounted on a flat surface or in a single- DIN opening as a replacement for an existing stereo. If you experience difficulty during the installation, contact Fusion Product Support. You must read all installation instructions before beginning the installation. NOTICE When drilling or cutting, always check what is on the opposite side of the surface. CAUTION Always wear safety goggles, ear protection, and a dust mask when drilling, cutting, or sanding. Before applying power to this product, make sure it has been correctly grounded, following the instructions in the guide. Disconnect the vessel's power supply before beginning to install this product. This device must be installed according to these instructions. See the Important Safety and Product Information guide in the product box for product warnings and other important information. 1 Fusion MS-RA70/MS-RA70N Installation Instructions Important Safety Information WARNING Failure to follow these warnings and cautions could result in personal injury, damage to the vessel, or poor product performance.

Fusion ms-ip700i software update